Version: 2.0.1
Version: 2.0.1b1
Date: 2017-12-06

1. Fixed a problem where the line outouts were swapped.

Version: 2.0.0
Date: 2017-11-14
Version: 1.0.3b1
Date: 2017-11-10

1. Changed GetDevice sysex command so that it no longer starts device discovery. This is common code that affects all products that use MIDIManager. Device discovery is prone to failure when there are MIDI feedback loops. A future version of MIDIManager will have a different mechanism for device discovery.
2. Fixed a problem with audio becoming distorted after several minutes. 
3. Fixed problem with user settings not getting erased properly on firmware update.

Version: 1.0.2
Version: 1.0.2b1
Date: 2017-03-15

1. Changed the USB audio descriptor to use synchronous endpoints for input and output when computer is the clock master, which is always is for this product (this change is needed for an upcoming Apple release).

Version: 1.0.1
Version: 1.0.1b2
Date: 2017-01-11

1. Fixed a problem where the unit would boot up in Line Out signal level mode but meters were actually showing Headphone signal level.
2. Fixed a buffer overflow problem that would cause intermittent problems with 1.0.0 and an immediate lockup with 1.0.1b1.

Version: 1.0.1b1
Date: 2016-12-29

1. Increased length of sysex buffer for internal messages from 127 to 159 (needed for processing AMP commands).
2. Modified the UI so that it is no longer possible to change the direct monitor input selection when direct monitoring is disabled. Direct monitor must be enabled (Direct LED = green or red) in order to select/deselect input channels 1 and 2. 
3. Added rules for device name, MIDI/audio port names, audio channel names, and various other nameable objects. Some users were doing things like giving ports blank names or names beginning with a minus sign that were causing problems with various operating systems. The new rules should help prevent that from happening. This is common code that affects all products using MIDIManager.
4. Changed factory default setting so that both inputs are selected for direct monitoring on power up. Previously, no inputs were selected for direct monitoring on power up.
5. Fixed an error where phantom power was enabled on power up if it had been enabled when settings were last saved. As a rule, we do not automatically enable phantom power on startup. Worse was that the UI indicated phantom power was not active on power up when in fact it was active on power up.
6. Modified the UI so that it is no longer possible to switch between mono and stereo mode when direct monitoring is disabled. Previously, touching the 48V/Inst button (when direct monitoring was disabled) would change between mono and stereo mode but the Direct LED would not change between green and red and since there was no signal going to the headphones it seemed as if the unit was broken. Now, touching the 48V/Inst button (when direct monitoring was disabled) will select 48V (phantom power) function. The behavior of the 48V/Inst button is unchanged when direct monitoring is enabled.

Version: 1.0.0
Date: 2016-09-01

First release for manufacturing test.