Sat, 02/20/2016 - 06:13 -- rjkillinger

Issues upgrading firmware on iConnectMIDI4+ on Mac and device is stuck in boot loader mode.

iConnectMIDI4+ firmware upgrade can only be done when the computer is connected to the USB 3 Device Jack on iConnectMIDI4+.
iConnectMIDI4+ firmware port

  • Disconnect any devices on the iConnectMIDI4+ and disconnect the iConnectMIDI4+ from your computer.
  • Open your Mac’s Audio MIDI Setup and remove any iConnectMIDI4+ you may find in the MIDI Studio Window.

    iConnectMIDI4+ MIDI Studio - Audio MIDI Setup

  • Re-connect the computer to iConnectMIDI4+ USB 3 device Jack and open iConfig.
  •  

  • ​iConfig should recognize the iConnectMIDI4+ in boot loader mode and when selected from the 'Device selection' screen, it should prompt for firmware upgrade again.
    Accept to upgrade and iConfig should properly upgrade the device.